Bellevue Gardens Apts.
INSTRUCTIONS ON USE OF APARTMENT THERMOSTAT

Exhibit A Thermostat Closed	Exhibt B Thermostat Open

Located in each apartment is a thermostat that controls the temperature in the apartment unit. The thermostat controls both the heat and air conditioning. In order for you to save electric useage, thusly reducing your monthly billing from Cincinnati Gas and Electric we have prepared this informational sheet.

The following are instructions on how to use your thermostat in your apartment unit to adjust the heating and cooling to your desired temperature.

GENERAL

1. Locate the thermostat on one of the walls in the apartment unit.
2. Please use Exhibit A above to assist you to recognize and clearly identify that you have found the thermostat.
3. A temperature reading should be visible on the thermostat.
4. Upon opening the door on the thermostat (see Exhibit B above) you should notice whether the word “heat”, “cool” or “auto” appears in the area where the temperature appears. Look on the left side of the temperature numbers for one of these three indicators. If it is not on the word “auto” push the mode button until the word “auto” appears.

IF YOU WANT TO INCREASE THE TEMPERATURE

5. If the temperature reads 72 degrees and you want to make it warmer use the arrow button pointing up (located on the right side of the thermostat – see Exhibit A) to increase the number 72 to the desired temperature number.
6. The thermostat will interpret your desire to increase the temperature to the new temperature you entered and now appearing on the thermostat and will automatically reset the control to the new desired temperature. You should see the word “reset” appear in the area where the numbers appear (watch in upper right hand corner). This means that the temperature has been reset to your new temperature.
7. The temperature should begin to increase to the new desired temperature.
8. Check the thermostat approximately two hours after you have reset the temperature to insure that the temperature has changed to what you set it at.

IF YOU WANT TO MAKE IT COOLER

9. If the temperature reads 75 degrees and you want to make it cooler use the arrow button pointing down (located on the right side of the thermostat – see Exhibit A) to decrease the number 75 to 72 or the desired temperature number.
10. The thermostat will interpret your desire to decrease the temperature to the new temperature you entered and will automatically reset the control to the new desired temperature. You should see the word “reset” appear in the area where the numbers appear (watch in upper right hand corner). This means that the temperature has been reset to your new temperature.
11. The temperature should begin to decrease to the new desired temperature.
12. Check the thermostat approximately two hours after you have reset the temperature to insure that the temperature has changed to what you set it at.